Scroll muis om in of uit te zoomen

DAA 2 in 1 Seating and Crimping Die

€ 29,50
BTW:
Inclusief belasting

DAA 2 in 1 Seating and Crimping Die

Referentie:

Beschikbaarheid:
Product is beschikbaar met verschillende opties
Kaliber:
Aantal:

Print

DAA 2 in 1 Seating and Crimping Die

This die frees up a station in your progressive-press tool head, making space for a bullet dropper die on your 550, or, allows you to use a bullet dropper alongside a powder-check on your 650 or 1050.
Adjusting the Die:
Back out the Bullet Seater adjustment screw several turns (the smaller diameter cap on top of die body).
Raise your shell plate all the way up (or lower your tool head on a 1050) and screw in the die body until it makes contact with the shell plate. Then, back it out three full turns. Lightly finger tighten the lock ring. Bullet length is adjusted by turning the Bullet Seater adjustment screw in or out as needed. If more crimp is desired, screw the die body in slightly and test repeatedly until the correct amount of crimp is achieved. Note that you will have to adjust the Bullet Seater height as you adjust the crimp.  

0 Item

Datasheet

Soort Herladen
Die sets en Toebehoren
#htmlcaption1